Home › General › MAINTENANCE › ENGINE

ENGINE > GENERAL MAINTENANCE


HINT:
Perform these procedures after the engine has cooled down.



1. INSPECT DRIVE BELT
Type
See procedure
1NZ-FE
Click here
2NZ-FE
Click here


2. INSPECT SPARK PLUGS
Type
See procedure
1NZ-FE
Click here
2NZ-FE
Click here


3. INSPECT BATTERY
Type
See procedure
1NZ-FE
Click here
2NZ-FE
Click here


4. INSPECT AIR CLEANER FILTER
  1. Remove the air cleaner filter.

  1. Visually check that the air cleaner filter is not excessively damaged or oily.

  1. Replace the air cleaner filter with a new one if necessary.



5. REPLACE AIR CLEANER CASE
  1. Check if foreign matter has accumulated in the bottom of the air cleaner case. If foreign matter has accumulated in the bottom of the air cleaner case, clean the air cleaner case.

    NOTICE:
    When cleaning the air cleaner case, prevent any foreign matter from entering into the engine.



6. REPLACE ENGINE OIL AND OIL FILTER
Type
See procedure
1NZ-FE
Click here
2NZ-FE
Click here


7. INSPECT ENGINE COOLANT
Type
See procedure
1NZ-FE
Click here
2NZ-FE
Click here


8. REPLACE ENGINE COOLANT
Type
See procedure
1NZ-FE
Click here
2NZ-FE
Click here


9. INSPECT GASKET IN FUEL TANK CAP
Type
See procedure
1NZ-FE
Click here
2NZ-FE
Click here


10. INSPECT FUEL LINES AND CONNECTIONS, FUEL TANK VAPOR VENT SYSTEM HOSES
  1. Visually check the fuel lines for cracks, leakage, loose connections, deformation or tank band looseness.



11. INSPECT EXHAUST PIPES AND MOUNTINGS
  1. Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.



12. INSPECT CHARCOAL CANISTER
Type
See procedure
1NZ-FE
Click here
2NZ-FE
Click here