Home › Vehicle Interior › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the key reminder warning system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE
    1. Check the battery voltage.

    2. Standard voltage:
      11 to 14 V

      HINT:
      If the voltage is below 11 V, recharge or replace the battery before proceeding.


    NEXT


    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use an intelligent tester to check if the CAN communication system is functioning normally.

      HINT:
      1. for Separate Type Yaw Rate Sensor (Click here).
      2. except Separate Type Yaw Rate Sensor (Click here).

      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output (for Separate Type Yaw Rate Sensor)
      B
      DTC is output (except Separate Type Yaw Rate Sensor)
      C



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)

    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here).
    A


    4.PROBLEM SYMPTOMS TABLE
      Result 
      Result
      Proceed to
      Fault is not listed on Problem Symptoms Table
      A
      Fault is listed on Problem Symptoms Table
      B


    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here).

    2. Data list/Active test (Click here).


    NEXT


    6.REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END