LIGHTING SYSTEM > Interior Light Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Turn the map light assembly switch to the DOOR position.
All doors closed (door courtesy light switches OFF).
Enter the following menus: Body / Main Body / Active Test.
According to the display on the intelligent tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Illuminated Entry System | Map light assembly | OFF or ON | Map light switch at DOOR position and all doors closed. |
|
| ||||
| OK | ||
| ||
| 2.INSPECT MAP LIGHT ASSEMBLY |
Inspect the map light assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - BATTERY) |
![]() |
Disconnect the 3C instrument panel junction block assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3C-4 - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Instrument Panel Junction Block Assembly) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (MAP LIGHT ASSEMBLY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) |
Disconnect the L9 map light assembly connector.
Disconnect the 3A and 3B instrument panel junction block assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L9-3 (B) - 3A-5 | Always | Below 1 Ω |
| L9-2 (CTY) - 3B-6 | Always | Below 1 Ω |
| L9-3 (B) - Body ground | Always | 10 kΩ or higher |
| L9-2 (CTY) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Remove the instrument panel junction block assembly.
Remove the main body ECU from the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.

| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | - | - |
| Tester Connection | Condition | Specified Condition |
| 3C-4 - 3A-5 | Always | Below 1 Ω |
| 3B-6 - MB-1 (ILE) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||