Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER (for RHD)

BRAKE BOOSTER (for RHD) > REMOVAL

for Preparation Click here


NOTICE:
Release the vacuum from booster by depressing the brake pedal several times.
Then remove the brake master cylinder from brake booster.



1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B284272
  1. Remove the 2 <A> screws.

  1. Disengage the claw and the guide and remove the instrument panel under cover.



2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)


  1. for LHD:



      B284274
    1. Disengage the 2 clips and the 5 claws and remove the instrument panel finish panel.



  1. for RHD:



      B272572
    1. Disengage the 2 clips and the 6 claws and remove the instrument panel finish panel.



3. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
(Click here)


4. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
(Click here)


5. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
(Click here)


6. REMOVE FRONT NO. 1 VENTILATOR SEAL


A249556
  1. Disengage the clamp and remove the front No. 1 ventilator seal.



7. REMOVE FRONT AIR SHUTTER SEAL RH

HINT:
Use the same procedure as for the No. 1 ventilator seal.



8. REMOVE INNER COWL TOP TO COWL BRACE


A249554
  1. Remove the 2 bolts and the inner cowl top to cowl brace.



9. REMOVE OUTER COWL TOP PANEL


A249552
  1. Disengage the 2 clamps and separate the wire harness.



  1. Remove the 8 bolts and the outer cowl top panel.


    A249553



10. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS


C107594
  1. Remove the brake pedal return spring.

  1. Loosen the push rod clevis lock nut.

  1. Remove the clip and push rod pin and separate the push rod clevis from the brake pedal.

  1. Remove the push rod clevis and push rod lock nut from the brake booster assembly.



11. REMOVE BRAKE BOOSTER ASSEMBLY


C235200
  1. Slide the clip and disconnect the vacuum hose from the vacuum check valve.

  1. Separate the wire harness clamp.



    C233664
  1. Separate the wire harness clamp and 4 nuts and remove the brake booster assembly.

    NOTICE:
    Do not damage the brake tubes.

  1. Remove the gasket from the brake booster assembly.