Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (for Separate Type Yaw Rate Sensor)

DTC    C1420    Acceleration Sensor Malfunction

for Preparation Click here


DESCRIPTION

Refer to DTCs C1419 and C1435 .

DTC Code
DTC Detection Condition
Trouble Area
C1420
After the difference between GL1 and GL2 becomes 0.6 G or more with the vehicle stationary, the difference remains 0.4 G or more for 60 seconds or more.
  1. Sensor installation
  2. Yaw rate and deceleration sensor (yaw rate sensor)

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 .

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Check if CAN communication system DTCs are output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
CHECK CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK YAW RATE AND DECELERATION SENSOR (YAW RATE SENSOR)
  1. Check that the yaw rate and deceleration sensor (yaw rate sensor) is installed properly (Click here).

    OK:
    The sensor is tightened to the specified torque.
    The sensor is not installed at an angle.



NG
INSTALL YAW RATE AND DECELERATION SENSOR (YAW RATE SENSOR) CORRECTLY (Click here)
OK

REPLACE YAW RATE AND DECELERATION SENSOR (YAW RATE SENSOR) (Click here)