Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1581    Assist Map Number Un-Writing

for Preparation Click here


DESCRIPTION

The power steering ECU assembly outputs this DTC when it determines that the assist map is not written in the ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1581
Assist map not written in power steering ECU assembly
  1. Power steering ECU assembly
  2. CAN communication system
  3. ECM

INSPECTION PROCEDURE

NOTICE:
  1. If the power steering ECU assembly has been replaced, perform the torque sensor zero point calibration and assist map writing (Click here).

1.PERFORM ASSIST MAP WRITING
  1. Perform assist map writing (Click here).


NEXT


2.CONFIRM DTC
  1. Check for DTCs (Click here).

    OK:
    DTC C1581 is not output.

    HINT:
    DTC C1581 will be cleared after the assist map is written.



NG
Go to step 3
OK

END 

3.CHECK CAN COMMUNICATION SYSTEM
  1. Check for DTCs of the CAN communication system.
    Yaw Rate Sensor Type
    See Page
    except Separate Type Yaw Rate Sensor
    Click here
    for Separate Type Yaw Rate Sensor
    Click here
    Result 
    Result
    Proceed to
    DTCs is not output
    A
    DTCs is output (except Separate Type Yaw Rate Sensor)
    B
    DTCs is output (for Separate Type Yaw Rate Sensor)
    C



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


4.CHECK ECM
  1. Check if an ECM that complies with the vehicle specifications is installed.

    OK:
    The ECM that complies with vehicle specifications is installed.

    Result 
    Result
    Proceed to
    OK (for LHD)
    A
    OK (for RHD)
    B
    NG (for 1NZ-FE)
    C
    NG (for 2NZ-FE)
    D



B
REPLACE POWER STEERING ECU ASSEMBLY (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)
A

REPLACE POWER STEERING ECU ASSEMBLY (Click here)