CRUISE CONTROL SYSTEM > Cruise Control Switch Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER (CRUISE CONTROL MAIN SWITCH) |
Using the intelligent tester, read the Data List (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Main SW M-CPU | Cruise control main switch (Main CPU) / OFF or ON | OFF: Cruise control main switch off ON: Cruise control main switch on | - |
| Cancel Switch | CANCEL switch signal / OFF or ON | OFF: CANCEL switch off ON: CANCEL switch on | - |
| SET/COAST Switch | -SET switch signal / OFF or ON | OFF: -SET switch off ON: -SET switch on | - |
| RES/ACC Switch | +RES switch signal / OFF or ON | OFF: +RES switch off ON: +RES switch on | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT CRUISE CONTROL MAIN SWITCH |
Inspect the cruise control main switch (Click here).
|
| ||||
| OK | |
| 3.INSPECT CRUISE CONTROL SWITCH WIRE |
![]() |
Remove the cruise control switch wire.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| z7-3 (CCS) - 3 (CCS) | Always | Below 1 Ω |
| z7-4 (ECC) - 1 (ECC) |
| *a | Front view of wire harness connector (to Spiral Cable Sub-assembly) |
| *b | Front view of wire harness connector (to Cruise Control Switch) |
|
| ||||
| OK | |
| 4.INSPECT SPIRAL CABLE SUB-ASSEMBLY |
Inspect the spiral cable sub-assembly (Click here).
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - ECM AND BODY GROUND) |
Disconnect the F5 spiral cable sub-assembly connector.
Disconnect the A74 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F5-1 (CCS) - A74-40 (CCS) | Always | Below 1 Ω |
| F5-2 (ECC) - Body ground | ||
| F5-1 (CCS) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
| OK | A |
| NG (for 2NZ-FE) | B |
| NG (for 1NZ-FE) | C |
|
| ||||
|
| ||||
| A | ||
| ||