QUARTER TRIM PANEL
REMOVAL
1. Remove the rear passenger seat cushion, (Refer to 23 - BODY/SEATS/SEAT CUSHION - REMOVAL).
2. Remove the rear seat back. (Refer to 23 - BODY/SEATS/SEAT BACK-REAR - REMOVAL)
3. Using a trim stick C-4755 or equivalent, disengage the retaining tabs that secure the upper C-pillar trim panel to the retaining clips in the C-pillar and position the panel and the seat belt out of the way.
4. Remove the rear passenger door sill scuff plate, (Refer to 23 - BODY/INTERIOR/DOOR SILL SCUFF PLATE - REMOVAL).
5. If equipped, remove the tonneau cover.
6. Remove the liftgate scuff plate, (Refer to 23 - BODY/INTERIOR/LIFTGATE SCUFF PLATE - REMOVAL).
7. Remove the upper liftgate trim panel, (Refer to 23 - BODY/INTERIOR/LIFTGATE OPENING UPPER TRIM - REMOVAL).
8. Remove the D-pillar trim panel, (Refer to 23 - BODY/INTERIOR/D-PILLAR TRIM - REMOVAL).
9. Remove the load floor, (Refer to 23 - BODY/INTERIOR/LOAD FLOOR - REMOVAL).
10. Remove the two screws that secure the quarter trim panel to the quarter panel.
11. Using a trim stick C-4755 or equivalent, disengage the retaining tabs that secure the quarter trim panel to the quarter panel.
12. Pull the quarter trim panel away from the quarter panel.
13. If equipped, disconnect the power outlet wire harness connector.
14. Remove the quarter trim panel.
INSTALLATION
1. Position the quarter trim panel in the vehicle.
2. If equipped, connect the wire harness connector to the power outlet.
3. Position the flange on the quarter trim panel into the seal ditch and secure the bottom clip first and then the middle clip.
4. Align the two fastener holes in the quarter trim panel with the two fastener holes in the quarter panel and engage the retaining tabs that secure the quarter trim panel to the quarter panel.
5. Install the two screws that secure the quarter trim panel to the quarter panel.
6. Install the load floor, (Refer to 23 - BODY/INTERIOR/LOAD FLOOR - INSTALLATION).
7. Install the D-pillar trim panel, (Refer to 23 - BODY/INTERIOR/D-PILLAR TRIM - INSTALLATION).
8. Install the upper liftgate trim panel, (Refer to 23 - BODY/INTERIOR/LIFTGATE OPENING UPPER TRIM - INSTALLATION).
9. Install the liftgate scuff plate, (Refer to 23 - BODY/INTERIOR/LIFTGATE SCUFF PLATE - INSTALLATION).
10. Position the locating tabs on the bottom of the upper C-pillar trim panel into the slots in the top of the quarter trim panel.
11. Align the retaining tabs on the upper C-pillar trim panel with the retaining clips in the C-pillar and engage the retaining tabs that secure the trim panel to the C-pillar.
12. Install the rear seat back. (Refer to 23 - BODY/SEATS/SEAT BACK-REAR - INSTALLATION)
13. Install the rear passenger seat cushion, (Refer to 23 - BODY/SEATS/SEAT CUSHION - INSTALLATION).
14. Install the rear passenger door sill scuff plate, (Refer to 23 - BODY/INTERIOR/DOOR SILL SCUFF PLATE - INSTALLATION).
15. If equipped, install the tonneau cover.