PROBLEM SYMPTOMS TABLE
Troubleshooting
- HINT:
- Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to the system before inspecting the suspected areas below.
- Inspect the fuses and relays related to the system before inspecting the suspected areas below.
| Symptom |
Suspected area |
See page |
| Power does not turn on (neither ACC nor IG is possible). |
1. AM2 Fuse |
Click here
|
| 2. Engine Switch | ||
| 3. Cowl Side J/B RH | ||
| 4. Cowl Side J/B LH | ||
| 5. IG2 Relay | ||
| 6. Wire Harness or Connector | ||
| 7. Power Source Control ECU | ||
| Power is not turned on (only ACC is not turned on). |
1. AM2 Fuse |
Click here
|
| 2. Cowl Side J/B RH | ||
| 3. Wire Harness or Connector | ||
| 4. Power Source Control ECU. | ||
| Power is not turned on (only IG is not turned on). |
1. AM2 Fuse |
Click here
|
| 2. Cowl Side J/B RH | ||
| 3. Cowl Side J/B LH | ||
| 4. IG2 Relay | ||
| 5. Wire Harness or Connector | ||
| 6. Power Source Control ECU | ||
| Engine does not start. |
1. Power Source Control ECU |
Click here
|
| 2. Certification ECU | ||
| 3. Shift Lock Control ECU | ||
| 4. ID Code Box | ||
| 5. Stop SW Fuse | ||
| 6. Stop Light Switch | ||
| 7. Electrical Steering Lock Function | ||
| 8. SFI System | ||
| 9. Engine Immobiliser System | ||
| 10. Wire Harness or Connector | ||
| Engine switch indicator light does not come on. |
Engine switch indicator light circuit |
Click here
|