Radio Receiver Communication Error

INSPECTION PROCEDURE

1. IDENTIFY THE COMPONENT SHOWN BY SUB-CODE

1. Enter the diagnostic mode.

2. Press the "LAN Mon" switch to change to "LAN Monitor" mode.

3. Identify the component shown by the sub-code.

   HINT:

   1. "110 (multi-display)" is the component shown by the sub-code in the example shown in the illustration.
      
   2. The sub-code will be indicated by its physical address.
      
   3. For the component list, refer to "DIAGNOSIS DISPLAY DETAILED DESCRIPTION" (Click here).
      

NEXT

2. CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE

1. Inspect the power source circuit of the component shown by the sub-code.If the power source circuit is operating normally, proceed to the next step.

   Component Table: 

   Component	Proceed to
   Gateway ECU (1C6)	Gateway ECU power source circuit (Click here)
   Stereo component amplifier (440)	Stereo component amplifier power source circuit (Click here)
   Multi-display (110)	Multi-display power source circuit (Click here)
   Navigation ECU (178)	Navigation ECU power source circuit (Click here)
   Television camera ECU (1AC)	Television camera ECU power source circuit (Click here)

NEXT

3. INSPECT RADIO RECEIVER

1. Disconnect the radio receiver connectors.

2. Measure the resistance according to the value(s) in the table below.

   Standard resistance:

   Tester Connection	Condition	Specified Condition
   ATX+ (J66-5) - ATX- (J66-15)	Always	60 to 80 Ω
   TX+ (J63-9) - TX- (J63-10)	Always	60 to 80 Ω

NG	REPLACE RADIO RECEIVER

OK

4. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT SHOWN BY SUB-CODE)

HINT:

1. Start the check from the circuit that is near the component shown by the sub-code first.
   
2. For details of the connectors, refer to "TERMINALS OF ECU" (Click here).
   

1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the radio receiver and the component shown by the sub-code.

   1. Disconnect all connectors between the radio receiver and the component shown by sub-code.

   2. Check for an open or short in the AVC-LAN circuit between the radio receiver and the component shown by the sub-code.

      OK:

      There is no open or short circuit.
      

      
      

NG	REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

5. REPLACE COMPONENT SHOWN BY SUB-CODE

1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

   OK:

   Same problem does not occur.
   

NG	REPLACE RADIO RECEIVER

OK
END