Home › Steering › Power Assist Systems › VANE PUMP
Last Modified: 11-27-2007 1.6 A
Service Category: Steering Section: Power Assist Systems
Model Year: 2008 Model: LX570 Doc ID: RM000002H5900GX
Title: POWER ASSIST SYSTEMS: VANE PUMP: INSTALLATION (2008 LX570)

INSTALLATION

1. INSTALL VANE PUMP ASSEMBLY

(a) Install the vane pump with the 2 bolts.

Torque: 21 N·m (214 kgf·cm, 15 ft·lbf)

2. CONNECT PRESSURE FEED TUBE



(a) Install a new gasket to the pressure feed tube.

(b) Connect the pressure feed tube with the union bolt.

Torque: 50 N·m (510 kgf·cm, 37 ft·lbf)

3. CONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR



(a) Connect the connector.

(b) Attach the wire harness clamp.

4. CONNECT SUCTION HOSE

(a) Connect the suction hose to the vane pump assembly with the clip.

5. INSTALL FAN AND GENERATOR V BELT 3UR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION (2008 LX570)+

6. INSTALL AIR CLEANER ASSEMBLY 3UR-FE ENGINE MECHANICAL: ENGINE ASSEMBLY: INSTALLATION (2008 LX570)+

7. INSTALL AIR CLEANER HOSE ASSEMBLY 3UR-FE INTAKE / EXHAUST: INTAKE MANIFOLD: INSTALLATION (2008 LX570)+

8. INSTALL V-BANK COVER SUB-ASSEMBLY 3UR-FE ENGINE MECHANICAL: ENGINE ASSEMBLY: INSTALLATION (2008 LX570)+

9. INSTALL FRONT FENDER APRON SEAL FRONT RH 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION (2008 LX570)+

10. INSTALL FRONT WHEEL RH BRAKE (FRONT): FRONT BRAKE: INSTALLATION (2008 LX570)+

11. ADD POWER STEERING FLUID

12. BLEED POWER STEERING FLUID POWER ASSIST SYSTEMS: POWER STEERING SYSTEM: ON-VEHICLE INSPECTION (2008 LX570)+

13. INSPECT FOR POWER STEERING FLUID LEAK

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL