| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Drivetrain | Section: Transfer/4wd/Awd | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM0000030S7006X |
| Title: JF2A TRANSFER / 4WD / AWD: TRANSFER CASE FRONT OIL SEAL: REPLACEMENT (2008 LX570) | ||
REPLACEMENT
1. DRAIN TRANSFER OIL
2. REMOVE FRONT PROPELLER SHAFT ASSEMBLY
(a) Remove the front propeller shaft
.
3. REMOVE FRONT OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
4. REMOVE TRANSFER CASE FRONT OIL SEAL
|
(a) Using SST, tap out the oil seal. SST: 09308-00010 NOTICE:
Be careful not to damage the oil seal and front transfer case contact surface. |
5. INSTALL TRANSFER CASE FRONT OIL SEAL
(a) Apply transfer oil to the spline of the driven sprocket.
|
(b) Using SST and a hammer, tap in a new oil seal until its surface is 1 to 1.5 mm (0.0394 to 0.0590 in.) from the case upper surface. SST: 09649-17010 SST: 09950-70010 09951-07150 |
6. INSTALL FRONT OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
7. INSTALL FRONT PROPELLER SHAFT ASSEMBLY
(a) Install the front propeller shaft
.
8. ADD TRANSFER OIL
9. CHECK FOR TRANSFER OIL LEAK
|
|