Home › Vehicle Interior › Seat › REAR NO. 1 SEAT ASSEMBLY (for RH Side)
Last Modified: 11-27-2007 1.6 A
Service Category: Vehicle Interior Section: Seat
Model Year: 2008 Model: LX570 Doc ID: RM000003912002X
Title: SEAT: REAR NO. 1 SEAT ASSEMBLY (for RH Side): INSTALLATION (2008 LX570)

INSTALLATION

1. INSTALL REAR SEAT CUSHION LOCK STRIKER SUB-ASSEMBLY

(a) Install the 4 strikers with the 10 bolts.

Torque: 37 N·m (377 kgf·cm, 27 ft·lbf)



2. INSTALL REAR NO. 6 AIR DUCT HEATING / AIR CONDITIONING: DUCT TEMPERATURE SENSOR: INSTALLATION (2008 LX570)+

3. INSTALL FRONT FLOOR CARPET ASSEMBLY HEATING / AIR CONDITIONING: DUCT TEMPERATURE SENSOR: INSTALLATION (2008 LX570)+

4. INSTALL REAR AIR DUCT GUIDE AUDIO / VIDEO: STEREO COMPONENT AMPLIFIER: INSTALLATION (2008 LX570)+

5. INSTALL AIR DUCT PLUG AUDIO / VIDEO: STEREO COMPONENT AMPLIFIER: INSTALLATION (2008 LX570)+

6. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

7. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

8. INSTALL REAR SEAT COVER CAP INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

9. INSTALL LUGGAGE COMPARTMENT NO. 1 TRIM HOOK INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

10. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

11. INSTALL REAR NO. 2 SEAT ASSEMBLY

(a) Install the rear No. 2 seat assembly SEAT: REAR NO. 2 SEAT ASSEMBLY (w/ Automatic Folding-up Function): INSTALLATION (2008 LX570) .

12. INSTALL REAR DOOR SCUFF PLATE LH INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

13. INSTALL REAR DOOR SCUFF PLATE RH INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

14. INSTALL REAR STEP COVER INTERIOR PANELS / TRIM: ROOF HEADLINING: INSTALLATION (2008 LX570)+

15. INSTALL REAR NO. 2 SEAT PROTECTOR



(a) Attach the 10 claws to install the 2 seat protectors.

16. INSTALL REAR NO. 1 SEAT PROTECTOR



(a) Attach the 10 claws to install the 2 seat protectors.

17. INSTALL REAR NO. 1 SEAT ASSEMBLY LH

(a) Install the rear No. 1 seat assembly LH SEAT: REAR NO. 1 SEAT ASSEMBLY (for LH Side): INSTALLATION (2008 LX570) .

18. INSTALL REAR NO. 1 SEAT ASSEMBLY RH



(a) Temporarily install the seat assembly with the 4 bolts.

NOTICE:

Be careful not to damage the vehicle body.

(b) Tighten the bolts in the order shown in the illustration.

Torque: 37 N·m (377 kgf·cm, 27 ft·lbf)


(c) Connect the connector.

(d) w/ Seat Heater System:

Connect the connector.

19. INSTALL REAR NO. 3 SEAT CUSHION HINGE COVER



(a) Attach the 2 clips and 2 claws to install the cover.

20. INSTALL REAR NO. 1 SEAT CUSHION HINGE COVER



(a) Attach the 2 clips and 2 claws to install the cover.

21. INSTALL REAR NO. 4 SEAT CUSHION HINGE COVER

(a) Return the seat to the upright position.

(b) Attach the 7 claws to install the cover.

22. INSTALL REAR NO. 2 SEAT CUSHION HINGE COVER



(a) Attach the 6 claws to install the cover.

23. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 LX570) .

24. INSTALL ENGINE ROOM SIDE COVER LH EXTERIOR PANELS / TRIM: RADIATOR GRILLE: INSTALLATION (2008 LX570)+

25. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: CHECK MODE PROCEDURE (2008 LX570) .

26. INSPECT REAR NO. 1 SEAT ASSEMBLY RH

(a) w/ Seat Heater System:

Check the seat heater operation.

(1) Turn the engine switch on (IG).

(2) Turn the seat heater switch on.

(3) Wait 5 minutes or more and confirm that the seat surface becomes warm.