| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Audio/Visual/Telematics | Section: Audio/Video | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003AWG002X |
| Title: AUDIO / VIDEO: SATELLITE RADIO TUNER: INSTALLATION (2008 LX570) | ||
INSTALLATION
HINT:
A bolt without a torque specification is shown in the standard bolt chart
.
1. INSTALL NO. 4 RADIO BRACKET
|
(a) Set the aligning protrusions of the bracket, labeled A, into the stereo component tuner holes. |
(b) Install the bracket with the 2 bolts labeled B.
2. INSTALL NO. 5 RADIO BRACKET
|
(a) Set the aligning protrusions of the bracket, labeled A, into the stereo component tuner holes. |
(b) Install the bracket with the 2 bolts labeled B.
3. INSTALL STEREO COMPONENT TUNER ASSEMBLY WITH BRACKET
|
(a) Install the stereo component tuner with the 3 bolts. |
(b) Connect the connectors.
4. INSTALL FRONT FLOOR CARPET ASSEMBLY
(a) Install the carpet that was pulled back to remove the tuner. For further details, refer to the installation procedure
.
5. INSTALL FRONT DOOR SCUFF PLATE RH
6. INSTALL COWL SIDE TRIM BOARD RH
7. INSTALL INSTRUMENT SIDE PANEL RH
8. INSTALL FRONT SEAT ASSEMBLY RH
(a) Install the front seat assembly RH
.
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
10. INSTALL ENGINE ROOM SIDE COVER LH
11. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light
.
|
|