| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Suspension | Section: Suspension Control System | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000003B20001X |
| Title: SUSPENSION CONTROL: SUSPENSION CONTROL CYLINDER: REMOVAL (2008 LX570) | ||
REMOVAL
1. REMOVE TAILPIPE ASSEMBLY
2. REMOVE CENTER EXHAUST PIPE ASSEMBLY
3. REMOVE HEIGHT CONTROL UNIT INSULATOR
4. DISCHARGE SUSPENSION FLUID PRESSURE
5. REMOVE NO. 7 HEIGHT CONTROL TUBE
6. REMOVE SUSPENSION CONTROL PUMP ACCUMULATOR ASSEMBLY
7. REMOVE CLAMP
8. REMOVE NO. 6 HEIGHT CONTROL TUBE
9. REMOVE NO. 6 HEIGHT CONTROL TUBE LH
10. REMOVE NO. 5 HEIGHT CONTROL TUBE LH
11. REMOVE NO. 5 HEIGHT CONTROL TUBE
12. DISCONNECT REAR NO. 4 HEIGHT CONTROL TUBE
13. REMOVE NO. 1 HEIGHT CONTROL VALVE ASSEMBLY
14. DISCONNECT NO. 3 HEIGHT CONTROL TUBE
(a) Remove the union bolt and gasket, then disconnect the No. 3 height control tube from the control cylinder.
15. DISCONNECT NO. 4 HEIGHT CONTROL TUBE LH
(a) Remove the union bolt and gasket, then disconnect the No. 4 height control tube from the control cylinder.
16. DISCONNECT NO. 4 HEIGHT CONTROL TUBE
(a) Remove the union bolt and gasket, then disconnect the No. 4 height control tube from the control cylinder.
17. DISCONNECT NO. 3 HEIGHT CONTROL TUBE LH
(a) Remove the union bolt and gasket, then disconnect the No. 3 height control tube from the control cylinder.
18. REMOVE HEIGHT CONTROL BRACKET WITH CYLINDER ASSEMBLY
(a) Remove the 2 bolts and bracket with cylinder.
19. REMOVE CENTER SUSPENSION CONTROL CYLINDER SUB-ASSEMBLY
(a) Remove the 2 nuts and cylinder from the bracket.
|
|