2018 / ECLIPSE CROSS / EC - Workshop Manual
17 -ENGINE AND EMISSION CONTROL > ADAPTIVE CRUISE CONTROL SYSTEM (ACC) > DIAGNOSIS CODE PROCEDURES > CODE NO. U1004: AS&G CAN TIMEOUT
Code No. U1004: AS&G CAN Timeout
| caution | - If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
- Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
- When the ACC/FCM-ECU is replaced, calibrate the radar (refer to
).
|
OPERATION
The ACC/FCM-ECU communicates with the engine-ECU (AS&G system) via the CAN bus lines.
DIAGNOSIS CODE SET CONDITION
Check Condition
- Ignition switch is "ON" position.
Judgement Criterion
- The signal sent from the engine-ECU (AS&G system) cannot be received for a certain period.
PROBABLE CAUSES
- Malfunction of the CAN bus line
- Malfunction of the engine-ECU
- Malfunction of the ACC/FCM-ECU
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE CAN bus diagnostics.
STEP 2. Check the other system diagnosis code.
STEP 3. Check whether the diagnosis code is set again.
STEP 4. Check whether the diagnosis code is set again.