DTC P213B
Precautions: General safety (00)
DTC Detecting Condition and Trouble Area
| DTC detecting condition | Trouble area |
|---|---|
|
P213B: Exhaust Gas Recirculation Throttle Control Circuit “B” Range / Performance EGR-2 valve is stuck in open position. (3 D/C detecting logic) |
•EGR-2 valve and/or its circuit
•ECM |
Circuit Diagram
| [A]: | ECM connector (View: [a]) | B1: | EGR-2 valve position sensor power supply circuit | 1. | ECM |
| A1: | EGR-2 valve (+) drive circuit | B2: | EGR-2 valve position sensor signal circuit | 2. | EGR-2 valve motor |
| A2: | EGR-2 valve (–) drive circuit | B3: | EGR-2 valve position sensor ground circuit | 3. | EGR-2 valve position sensor |
DTC Troubleshooting
| Step | Action | Yes | No |
|---|---|---|---|
| 1 |
Was “Engine and Emission Control System Check” performed?
|
Go to Step 2.
|
|
| 2 |
EGR-2 valve (+) drive circuit and (–) drive circuit check
1)Check “A1” and “A2” circuits according to Step 2 of EGR-2 Valve Operation Check:D16AA.
Is check result OK?
|
Go to Step 3.
|
Repair or replace defective wire harness.
|
| 3 |
EGR-2 valve position sensor power supply circuit, signal circuit and ground circuit check
1)Check “B1”, “B2” and “B3” circuits according to Step 3 – 6 of EGR-2 Valve Position Sensor Check:D16AA.
Is check result OK?
|
Go to Step 4.
|
Repair or replace defective wire harness.
|
| 4 |
EGR-2 valve position sensor check
1)Check EGR-2 valve position sensor.
Is check result OK?
|
Replace ECM and recheck DTC.
|
Replace EGR-2 valve.
|