Scan Tool Data
Precautions: Precautions for Diagnosing Trouble · Precautions for Replacing Ignition Key (Ignition Switch Model) · Precautions for Transmitter Disposal (Ignition Switch Model) · Precautions for Replacing Keyless Entry Control Module (Ignition Switch Model) · Precautions for Body, Cab and Accessories · General safety (00)
Keyless Entry Control Module
NOTE:
•If communication between SUZUKI scan tool and keyless entry control module is not possible, perform the following checks:
•Select “Keyless Start” menu on SUZUKI scan tool.
—Check communication condition between PC and VCI using SUZUKI scan tool function.
—Check DLC power circuit and ground circuit.
—Check DLC cable. If necessary, check DLC cable by substituting a known-good DLC cable.
—Check CAN communication system. (“Control Module Communication Bus Off” is detected in any control module.)
•*1: Data with asterisk 1 (*1) in the table below may either be applicable or not applicable depending on the model.—Check DLC power circuit and ground circuit.
—Check DLC cable. If necessary, check DLC cable by substituting a known-good DLC cable.
—Check CAN communication system. (“Control Module Communication Bus Off” is detected in any control module.)
—M16A model:
—D16AA model:
—Check keyless entry control module power circuit and ground circuit. —D16AA model:
•Select “Keyless Start” menu on SUZUKI scan tool.
| Scan tool data | Normal condition / Reference value | Condition |
|---|---|---|
| Battery Voltage | 10 – 14 V | Engine: Running |
| Vehicle Speed | Almost the same as speedometer reading | In driving |
| Engine Speed | M16A model: 550 – 650 rpm D16AA model: Approx. 800 rpm |
Engine: Idle speed with no load applied after warming up |
| Driv Door SW | Open | Driver door: Opened |
| Close | Other than above condition | |
| Pass Door SW | Open | Other than driver door: Opened |
| Close | Other than above condition | |
| Rear End Door Opener | ON | Rear end door opener switch: Pushed |
| OFF | Other than above condition | |
| Back Door/Trunk SW | ON | Rear end door: Opened |
| OFF | Other than above condition | |
| Starting Motor Relay (Com) (*1) | ON | Engine: Cranking |
| OFF | Other than above condition | |
| Door Key SW (Lock) | ON | Driver key cylinder: Lock position |
| OFF | Other than above condition | |
| Door Key SW (Unlock) | ON | Driver key cylinder: Unlock position |
| OFF | Other than above condition | |
| Hood Switch (*1) | ON | Hood: Opened |
| OFF | Other than above condition | |
| Key Reminder SW | KeyIn | Ignition key: Inserted in ignition key cylinder |
| Pulled | Other than above condition | |
| Ignition Switch1 | ON | Ignition: “ON” |
| OFF | Other than above condition | |
| Accessory Switch | ON | Ignition: “ACC” and “ON” |
| OFF | Other than above condition | |
| Security Alarm (*1) | Active | Security alarm setting: Active mode |
| Disabled | Security alarm setting: Disabled mode | |
| Answer-back | Hazard | Answer-back setting: Hazard mode |
| Interior | Answer-back setting: Dome light mode |