9F Security and Locks
Precautions
- Precautions for Diagnosing Trouble
- Precautions for Replacing Ignition Key (Ignition Switch Model)
- Precautions for Transmitter Disposal (Ignition Switch Model)
- Precautions for Replacing Keyless Entry Control Module (Ignition Switch Model)
General Description
- Power Door Lock Description
- Deadlock System Description (If Equipped)
- Emergency Lever of Rear End Door Description
- Power Door Lock Operation Description
- CAN Communication System Description
Schematic and Routing Diagram
- Keyless Entry Control Module Input / Output Diagram
- Power Door Lock System Circuit Diagram
- Keyless Entry System Circuit Diagram
Component Location
Diagnostic Information and Procedures
- Keyless Entry System Check
- Keyless Entry Control Module Self-Diagnosis Function
- DTC Check
- DTC Clearance
- DTC Table
- Scan Tool Data
- Scan Tool Active Test Table
- Scan Tool Utility Table
- Power Door Lock System Symptom Diagnosis
- DTC B1120 Keyless Start Control Module Internal Defect; B1170 EEPROM Access Error
- DTC B1122 Backup Power Supply Malfunction
- DTC B1123 Backup Power Supply Malfunction
- DTC B1461 Vehicle Speed Signal Inconsistency
- DTC U0073 Troubleshooting for Communication Bus Off
- DTC U0100 Troubleshooting for Lost Communication
- DTC U0140 Troubleshooting for Lost Communication
- DTC U0155 Troubleshooting for Lost Communication
- Inspection of Keyless Entry Control Module and Its Circuits
Repair Instructions
- Front Door Lock Components
- Front Door Lock Assembly Removal and Installation
- Front Door Lock Assembly Inspection
- Rear Door Lock Components
- Rear Door Lock Assembly Removal and Installation
- Rear Door Lock Assembly Inspection
- Door Lock Switch and Actuator On-Vehicle Inspection
- Front and Rear Door Switch Inspection
- Power Door Lock Switch Inspection
- Rear End Door Lock Components
- Rear End Door Latch On-Vehicle Inspection
- Rear End Door Lock Removal and Installation
- Rear End Door Opener Switch On-Vehicle Inspection
- Rear End Door Opener Switch Removal and Installation
- Keyless Entry Control Module Removal and Installation (Ignition Switch Model)
- Hood Latch Switch Removal and Installation (If Equipped)
- Hood Latch Switch Inspection (If Equipped)
- Ignition Key Registration (Ignition Switch Model)
- Keyless Entry Control Module Registration (Ignition Switch Model)
- Replacement of Transmitter Battery (Ignition Switch Model)