DTC B1169
Precautions: Precautions for Diagnosing Trouble · General safety (00)
DTC Detecting Condition and Trouble Area
| DTC detecting condition | Trouble area |
|---|---|
|
B1169: Registration Failure Registration failure of ECM or remote controller. |
•Power supply circuit / connector
•CAN communication circuit / connector •ECM •Keyless start control module •ID controller (if equipped) |
DTC Troubleshooting
| Step | Action | Yes | No |
|---|---|---|---|
| 1 |
DTC check
Is there any DTC(s) other than B1169 detected?
|
Go to troubleshooting for applicable DTC.
|
Go to Step 2.
|
| 2 |
ECM registration
1)Perform ECM Registration:Keyless Push Start Model.
2)Check that ignition is “OFF”.
3)Set ignition “ON”.
4)Recheck DTC.
Is DTC B1169 still detected?
|
Replace ECM and recheck DTC.
•M16A model:
 •K14C model: •D16AA model: |
•Without ID controller: Replace keyless start control module and recheck DTC.
•With ID controller: Go to Step 3. |
| 3 |
Remote controller registration
1)Replace ID controller.
2)Perform “Immobilizer Key Registration”.
3)Check that ignition is “OFF”.
4)Set ignition “ON”.
5)Recheck DTC.
Is DTC B1169 still detected?
|
Replace keyless start control module and recheck DTC.
|
End. (ID controller was faulty)
|