DTC B1134
Precautions: Precautions for Diagnosing Trouble · Precautions for Replacing Remote Controller · Precautions for Remote Controller Disposal · Precautions for Replacing Keyless Start Control Module · Precautions for Control Systems · General safety (00)
DTC Detecting Condition and Trouble Area
| DTC detecting condition | Trouble area |
|---|---|
|
B1134: Remote Controller Battery Low Remote controller battery run down signal is received from remote controller. |
•Remote controller battery
•Remote controller |
DTC Confirmation Procedure
NOTE:
Prepare all registered remote controllers before performing DTC confirmation procedure.
1)Set ignition “ON”.
2)Check that “Remote Controller Battery Warning” setting is “Active” mode. 
3)Place remote controller within the keyless engine start operation area and open and close door more than 2 times.
4)Repeat Step 3) 6 times.
5)Perform Step 3) – 4) with all of registered remote controllers.
DTC Troubleshooting
| Step | Action | Yes | No |
|---|---|---|---|
| 1 |
Remote controller check
1)Prepare all registered remote controllers.
2)Set ignition “ON” with remote controller carried with oneself.
3)Check whether “KEY FOB LOW BATTERY” is shown in information display.
4)Set ignition “OFF”.
5)Perform Step 2) – 4) for all remote controllers.
Does “KEY FOB LOW BATTERY” show in information display?
|
Go to Step 2.
|
End. (Remote controller battery run down signal was detected in the past. (DTC is not cleared))
|
| 2 |
Remote controller battery check
1)Replace battery of corresponding remote controller with new one.
2)Clear DTC.
3)Perform DTC Confirmation Procedure and then recheck DTC.
Is DTC B1134 still detected?
|
Replace remote controller and recheck DTC.
|
End.
|