DTC C1610 / C1618
Precautions: Precautions for Diagnosing Trouble · Precautions for RBS System · Precautions for Servicing RBS System · Precautions for Removing / Installing and Replacing RBS Control Module · Precautions for Control Systems · General safety (00)
DTC Detecting Condition and Trouble Area
| DTC detecting condition | Trouble area |
|---|---|
|
C1610: Sensor Not Aligned “Millimeter Wave Radar Aiming Adjustment” is not performed or not completed. |
RBS control module |
|
C1618: Sensor Misaligned Deviation of beam axis from millimeter wave radar in right and left is detected. |
DTC Confirmation Procedure
1)Set ignition “ON”.
DTC Troubleshooting
| Step | Action | Yes | No |
|---|---|---|---|
| 1 |
Was “RBS System Check” performed?
|
Go to Step 2.
|
Go to RBS System Check.
|
| 2 |
DTC check
1)Perform Millimeter Wave Radar Aiming Adjustment.
2)Set ignition “OFF”.
3)Perform DTC Confirmation Procedure and then recheck DTC.
Is DTC C1610 or C1618 still detected?
|
Replace RBS control module and recheck DTC.
|
End.
|