Section 3 - Driveline / Axle
Section 3 - Driveline / Axle
Section 3A - Drive Shaft / Axle
Front
| Reference | Specification |
|---|---|
 |
Grease specification for front drive shaft wheel side joint |
|
|
Boot band fastening distance “a” |
|
|
Drive shaft damper No.1 installing position (distance between wheel side joint end and damper end) |
|
|
Damper band fastening distance |
|
|
Drive shaft damper No.2 installing position (distance between wheel side joint end and damper end) |
|
|
Boot band fastening Distance |
|
|
Grease specification for differential side (transfer side or drive intermediate shaft side) joint of front drive shaft |
|
|
Drive shaft boot fixing position (distance between differential side joint end and boot small band center) |
|
|
Install each boot band using the appropriate method referring to the following table |
|
|
Boot band fastening distance “a” |
|
|
Distance between bearing support surface and dust seal |
Rear
| Reference | Specification |
|---|---|
|
|
Grease specification for rear drive shaft wheel side joint |
|
|
Grease specification for rear drive shaft differential side joint |
|
|
Drive shaft boot fixing position (distance between differential side joint end and boot small band center) |
Section 3B - Differential
| Reference | Specification |
|---|---|
|
|
Rear differential oil specification |
|
|
Viscosity chart |
|
|
Driving mode switch resistance |
|
|
Rear drive coupling unit resistance |
|
|
Bevel gear backlash |
|
|
Bevel pinion bearing preload (Bevel pinion rotational torque) |
|
|
Companion flange inside diameter runout |
|
|
Bevel pinion bearing preload (special tool rotational torque) |
|
|
Available bevel pinion shim thickness |
|
|
Distance between differential carrier and oil seal |
|
|
Bevel pinion bearing preload (Bevel pinion rotational torque) |
|
|
Differential side gear thrust play |
|
|
Available side washer thickness |
|
|
Available differential side shim thickness |
|
|
Bevel gear backlash |
|
|
Bevel pinion bearing preload (Bevel pinion rotational torque) |
|
|
Distance between case and oil seal |
Section 3C - Transfer
| Reference | Specification |
|---|---|
|
|
Transfer oil specification |
|
|
Viscosity chart |
|
|
Transfer intermediate output oil seal installing depth |
|
|
Rotational torque of bevel pinion (Bearing preload) |
|
|
Available transfer output retainer shim thickness |
|
|
Transfer output flange oil seal installing position |
|
|
Bevel pinion bearing preload |
|
|
Oil seal (outer) installing position (from bearing end position to oil seal surface) |
|
|
Oil seal (inner) installing position (depth from bearing installation surface of case to oil seal surface) |
|
|
Available reduction driven gear left shim (2) thickness |
|
|
Available reduction driven gear right shim (4) thickness |
|
|
Bevel pinion & bevel gear backlash |
|
|
Sealant amount for right case |
Section 3D - Propeller Shaft
| Reference | Specification |
|---|---|
|
|
Propeller shaft runout |