22030
1.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY
Install a new gasket and the throttle body with motor assembly with the 4 bolts.
Connect the throttle position sensor and throttle control motor connector.
Connect the No. 4 water by-pass hose.
Connect the No. 5 water by-pass hose.
17881
2.INSTALL NO. 1 AIR CLEANER HOSE
3.ADD ENGINE COOLANT
4.INSPECT FOR ENGINE COOLANT LEAK
51405A
5.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
52129B
6.INSTALL FRONT BUMPER LOWER COVER (w/o TOYOTA Parking Assist-sensor System)
52822
7.INSTALL AIR INTAKE DUCT LH (w/ TOYOTA Parking Assist-sensor System)
52821
8.INSTALL AIR INTAKE DUCT RH (w/ TOYOTA Parking Assist-sensor System)
52129B
9.INSTALL FRONT BUMPER LOWER COVER (w/ TOYOTA Parking Assist-sensor System)
53298
10.INSTALL COOL AIR INTAKE DUCT (for 4WD with TOYOTA Parking Assist-sensor System)
11259
11.INSTALL V-BANK COVER
53292A
12.INSTALL UPPER RADIATOR SUPPORT SEAL
13.PERFORM INITIALIZATION
Be sure to perform this procedure after reassembling the throttle body or removing and reinstalling any throttle body component.
Perform the following procedure after replacing the ECM, throttle body or any throttle body components. The following procedure should also be performed if the throttle body is cleaned.
Be sure to perform this procedure after replacing the ECM and reconnecting the battery cable.
Disconnect the EFI and ETCS fuses at the same time. Wait at least 60 seconds, and then reconnect the fuses.
Turn the ignition switch to ON without operating the accelerator pedal.
If the accelerator pedal is operated, perform the above steps again.
Connect the intelligent tester to the DLC3 and clear the DTCs (See page Engine / Hybrid System>1GR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).
Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.
690 to 790 rpm
Be sure to perform this step with all accessories off.
Make sure that the shift lever is in neutral.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.
Perform a road test and confirm that there are no abnormalities.