Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM1440E _51 Engine / Hybrid System _056124 1GR-FE ENGINE CONTROL _0273868 CRANKSHAFT POSITION SENSOR A

1GR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401G 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the sensor.

NOTICE:
·

When reusing the sensor, inspect the O-ring.

·

If the O-ring has scratches or cuts, replace the sensor.




b.

Install the sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the sensor connector.


Hide 51405A 2.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 88320 3.INSTALL COOLER COMPRESSOR ASSEMBLY

a.

Hide 27020 4.INSTALL GENERATOR ASSEMBLY