Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › SFI SYSTEM
RM1440E _51 Engine / Hybrid System _056124 1GR-FE ENGINE CONTROL _0273876 SFI SYSTEM C

1GR-FE ENGINE CONTROL  SFI SYSTEM  P0116  Engine Coolant Temperature Circuit Range / Performance Problem  


DESCRIPTION

Refer to DTC P0115 (See page Engine / Hybrid System>1GR-FE ENGINE CONTROL>SFI SYSTEM>P0115).

DTC No. DTC Detection Condition Trouble Area
P0116 Engine coolant temperature is between 35°C and 60°C (95°F and 140°F) when the engine is started and conditions (a) and (b) are met (2 trip detection logic):
(a) Vehicle is driven at varying speeds (accelerated and decelerated).
(b) Engine coolant temperature remains within 3°C (5.4°F) of the initial engine coolant temperature.
·

Thermostat

·

Engine coolant temperature sensor



MONITOR DESCRIPTION

Engine coolant temperature sensor high side stuck monitor

The ECM monitors the sensor voltage and uses this value to calculate the engine coolant temperature. If the sensor voltage output deviates from the normal operating range, the ECM interprets this deviation as a malfunction in the engine coolant temperature sensor and stores the DTC.

Example:

Upon starting the engine, the engine coolant temperature is between 35°C and 60°C (95°F and 140°F). If, after driving for 250 seconds, the engine coolant temperature remains within 3°C (5.4°F) of the starting temperature, the DTC is stored (2 trip detection logic).



CAUTION / NOTICE / HINT

HINT:
·

If DTC P0115, P0117 or P0118 is stored simultaneously with DTC P0116, the engine coolant temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.

·

Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.



PROCEDURE

1.CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC.


e.

Read the DTCs.

Result
Result Proceed to
P0116 is output A
P0116 and other DTCs are output B



A

2.INSPECT THERMOSTAT

B

2.INSPECT THERMOSTAT
a.

b.

Measure the valve opening temperature of the thermostat.

Standard opening temperature:

80 to 84°C (176 to 183°F)


HINT:

In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.



c.


OK

NG