11381A
1.INSTALL REAR CRANKSHAFT OIL SEAL
Apply MP grease to the lip of a new oil seal.
Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
Keep the lip free from foreign matter.
Do not tap the oil seal at an angle.
32101
2.INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
35000
3.INSTALL AUTOMATIC TRANSMISSION ASSEMBLY
for 4WD:
Install the automatic transmission (See page Drivetrain>A750F AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION ASSEMBLY>INSTALLATION).
for 2WD:
Install the automatic transmission (See page Drivetrain>A750E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION ASSEMBLY>INSTALLATION).