Home › Engine / Hybrid System › 1GR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM1440E _51 Engine / Hybrid System _056125 1GR-FE ENGINE MECHANICAL _0273882 REAR CRANKSHAFT OIL SEAL A

1GR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 35000 1.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

Hide 32101 2.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

Hide 11381A 3.REMOVE REAR CRANKSHAFT OIL SEAL

a.
A076328E09
0.417,0.25 0.271,0.25 0.271,0.25 0.708,1.594 true 0.469,0.167 0.667,0.354 0.198,0.188 10 true *1

Using a knife, cut off the lip of the oil seal.

Text in Illustration
*1 Cut Position


b.

Using a screwdriver, pry out the oil seal.

HINT:

Tape the screwdriver tip before use.


NOTICE:

Do not damage the surface of the oil seal press fit hole or crankshaft.