1.DISCHARGE FUEL SYSTEM PRESSURE
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
53298
3.REMOVE COOL AIR INTAKE DUCT (for 4WD with TOYOTA Parking Assist-sensor System)
52129B
4.REMOVE FRONT BUMPER LOWER COVER (w/o TOYOTA Parking Assist-sensor System)
52129B
5.REMOVE FRONT BUMPER LOWER COVER (w/ TOYOTA Parking Assist-sensor System)
52822
6.REMOVE AIR INTAKE DUCT LH (w/ TOYOTA Parking Assist-sensor System)
52821
7.REMOVE AIR INTAKE DUCT RH (w/ TOYOTA Parking Assist-sensor System)
51405A
8.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
9.DRAIN ENGINE COOLANT
11259
10.REMOVE V-BANK COVER
Raise the front of the V-bank cover to detach the 2 pins. Then detach the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| *1 | Pin |
| *2 | V-bank Cover Hook |
17881
11.REMOVE NO. 1 AIR CLEANER HOSE
Disconnect the ventilation hose and vacuum hose.
Detach the wire harness clamp.
Remove the bolt and loosen the 2 hose clamps.
Remove the No. 1 air cleaner hose.
17360G
12.REMOVE AIR TUBE ASSEMBLY (w/ Secondary Air Injection System)
Disconnect the No. 1 air injection system hose from the air tube assembly.
for Bank 1 Side:
Remove the bolt and disconnect the air tube assembly from the No. 1 emission control valve set.
for Bank 2 Side:
Remove the 2 bolts and disconnect the air tube assembly from the No. 2 emission control valve set.
17129
13.REMOVE INTAKE AIR SURGE TANK
Disconnect the throttle body connector.
Disconnect the No. 4 water by-pass hose.
Disconnect the No. 5 water by-pass hose.
Disconnect the No. 1 fuel vapor feed hose.
Disconnect the No. 1 vacuum switching valve connector.
Disconnect the No. 1 ventilation hose.
Detach the 2 heater water hose clamps.
Remove the 2 bolts and throttle body bracket.
Using a clip remover, detach the wire harness clamp.
Remove the 2 bolts and No. 1 surge tank stay.
Remove the 2 bolts and No. 2 surge tank stay.
Remove the 2 nuts, 4 bolts and intake air surge tank.
Remove the gasket.
23801P
14.DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY
23802B
15.DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY
23807
16.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
17111
17.REMOVE INTAKE MANIFOLD
Remove the 4 nuts, 6 bolts, intake manifold and 2 gaskets.