Home › Engine / Hybrid System › 1GR-FE COOLING › THERMOSTAT › from 2013.08
RM1440E _51 Engine / Hybrid System _056129 1GR-FE COOLING _0273912 THERMOSTAT A

1GR-FE COOLING  THERMOSTAT  REMOVAL  


PROCEDURE

Hide 53298 2.REMOVE COOL AIR INTAKE DUCT (for 4WD with TOYOTA Parking Assist-sensor System)

Hide 52129B 3.REMOVE FRONT BUMPER LOWER COVER (w/o TOYOTA Parking Assist-sensor System)

Hide 52129B 4.REMOVE FRONT BUMPER LOWER COVER (w/ TOYOTA Parking Assist-sensor System)

Hide 52822 5.REMOVE AIR INTAKE DUCT LH (w/ TOYOTA Parking Assist-sensor System)

Hide 52821 6.REMOVE AIR INTAKE DUCT RH (w/ TOYOTA Parking Assist-sensor System)

Hide 51405A 7.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 16572 10.DISCONNECT NO. 2 RADIATOR HOSE

a.
A223077

Loosen the clamp and disconnect the No. 2 radiator hose from the water inlet.


Hide 16031 11.REMOVE WATER INLET WITH THERMOSTAT

HINT:

If the thermostat was not installed, cooling efficiency would decrease. Even if the engine tends to overheat, do not remove the thermostat.


a.
A223010

Remove the 3 nuts, water inlet with thermostat and gasket.