Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY
RM1440E _52 Drivetrain _056136 DRIVE SHAFT / PROPELLER SHAFT _0273960 FRONT DRIVE SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 43420 1.INSTALL FRONT DRIVE SHAFT ASSEMBLY

F042771

a.

Coat the spline of the inboard joint shaft assembly with ATF.


b.

Align the shaft splines and install the drive shaft with a brass bar and hammer.

NOTICE:
·

Set the snap ring with the opening side facing downward.

·

Be careful not to damage the oil seal, boot and dust cover.



HINT:

Whether the inboard joint shaft is in contact with the pinion shaft or not can be confirmed from the sound or feeling when driving it.



Hide 48626 3.INSTALL LOWER BALL JOINT ATTACHMENT LH

a.

Install the lower ball joint attachment with the 2 bolts.

Torque:
160 N*m (1631 kgf*cm, 118 ft.*lbf)


Hide 45047 4.CONNECT TIE ROD END SUB-ASSEMBLY LH

Hide 9.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 10.CHECK FRONT SPEED SENSOR

a.