Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM1440E _55 Steering _056149 STEERING GEAR / LINKAGE _0274025 STEERING GEAR A

STEERING GEAR / LINKAGE  STEERING GEAR  INSTALLATION  


PROCEDURE

Hide 44250 1.INSTALL RACK AND PINION POWER STEERING GEAR ASSEMBLY

a.

Install the steering gear assembly with the 2 bolts and 2 nuts.

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)

NOTICE:

Hold the nuts and tighten the bolts to install the power steering link assembly.



Hide 44410 2.CONNECT PRESSURE FEED TUBE ASSEMBLY

a.

Install the pressure feed tube clamp with the bolts.

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)


b.

Connect the pressure feed tube (return tube side) to the steering gear with the clamp.


c.

Using a union nut wrench, connect the pressure feed tube (pressure feed tube side) to the steering gear. Using a union nut wrench, connect the tube to the vane pump.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)

HINT:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 45047 3.CONNECT TIE ROD END SUB-ASSEMBLY LH

a.

Connect the tie rod end to the steering knuckle with the nut.

Torque:
91 N*m (928 kgf*cm, 67 ft.*lbf)

NOTICE:

Tighten the nut up to an additional 60° if the holes for the cotter pin are not aligned.



b.

Install a new cotter pin.


Hide 45046 4.CONNECT TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedures described for the LH side.


Hide 45203 5.CONNECT NO. 2 STEERING INTERMEDIATE SHAFT

a.

Connect the No. 2 steering intermediate shaft (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY>INSTALLATION).


Hide 6.INSTALL ENGINE ASSEMBLY

Hide 7.ADD POWER STEERING FLUID

Hide 8.BLEED AIR FROM POWER STEERING FLUID

a.

Bleed air from the power steering fluid (See page Steering>POWER ASSIST SYSTEMS>VANE PUMP>ON-VEHICLE INSPECTION).


Hide 9.CHECK FOR POWER STEERING FLUID LEAK

Hide 10.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 11.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 12.ADJUST FRONT WHEEL ALIGNMENT

a.