Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT DIFFERENTIAL CARRIER ASSEMBLY(for 4WD)
RM1440E _52 Drivetrain _056137 AXLE AND DIFFERENTIAL _0273977 FRONT DIFFERENTIAL CARRIER ASSEMBLY(for 4WD) A

AXLE AND DIFFERENTIAL  FRONT DIFFERENTIAL CARRIER ASSEMBLY(for 4WD)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 2.REMOVE FRONT WHEELS

Hide 51405A 3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 51450 4.REMOVE REAR ENGINE UNDER COVER ASSEMBLY

Hide 37140 6.REMOVE FRONT PROPELLER SHAFT ASSEMBLY

Hide 43420 7.REMOVE FRONT DRIVE SHAFT ASSEMBLY

Hide 48810 8.REMOVE FRONT STABILIZER LINK ASSEMBLY

a.

Remove the stabilizer link (See page Suspension>FRONT SUSPENSION>FRONT STABILIZER BAR>REMOVAL).


Hide 89543 9.REMOVE FRONT SPEED SENSOR

Hide 45047 10.DISCONNECT TIE ROD END SUB-ASSEMBLY LH

a.

Disconnect the tie rod end sub-assembly (See page Steering>STEERING GEAR / LINKAGE>STEERING GEAR>REMOVAL).


Hide 45046 11.DISCONNECT TIE ROD END SUB-ASSEMBLY RH

a.

Disconnect the tie rod end sub-assembly (See page Steering>STEERING GEAR / LINKAGE>STEERING GEAR>REMOVAL).


Hide 48069 12.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH

a.

Remove the front lower No. 1 suspension arm sub-assembly (See page Suspension>FRONT SUSPENSION>FRONT LOWER SUSPENSION ARM>REMOVAL).


Hide 48068 13.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 41110F 14.REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY

C097020E11
1.323,0.198 1.531,0.365 0.208,0.167 10 true *1 1.969,0.188 2.156,0.375 0.188,0.188 10 true *1 1.823,1.49 2.021,1.688 0.198,0.198 10 true *2

a.

Remove the bolt and disconnect the front differential breather tube bracket.


b.

Support the front differential with a jack.


c.

Remove the front No. 1 differential mount nut.


d.

Remove the 2 front mounting bolts and nut.

Text in Illustration
*1 Mounting Bolt
*2 Mounting Nut


e.

Disconnect the actuator hose and connector.


f.

Lower the jack and remove the front differential.


g.
B084273

Remove the 3 bolts and front No. 1 differential support.


h.
B084274

Remove the 2 bolts and front No. 2 differential support.


i.
B084275

Remove the 2 bolts and front No. 3 differential support.