84306
1.INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR
Install the spiral cable with steering angle sensor (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSTALLATION).
Do not replace the spiral cable with the battery connected and the ignition switch ON.
Do not rotate the spiral cable with the battery connected and the ignition switch ON.
Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
Do not remove the steering angle sensor from the spiral cable.
45286B
2.INSTALL UPPER STEERING COLUMN COVER
45287
3.INSTALL LOWER STEERING COLUMN COVER
84306
4.ADJUST SPIRAL CABLE
45100
5.INSTALL STEERING WHEEL ASSEMBLY
Install the steering wheel assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>INSTALLATION).
28800
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
7.CHECK SRS WARNING LIGHT
Check the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>SYSTEM DESCRIPTION).