Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0273998 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  REMOVAL  


PROCEDURE

Hide 1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45100 3.REMOVE STEERING WHEEL ASSEMBLY

a.

Remove the steering wheel assembly (See page Steering>STEERING COLUMN>STEERING WHEEL>REMOVAL).


Hide 45287 4.REMOVE LOWER STEERING COLUMN COVER

Hide 45286B 5.REMOVE UPPER STEERING COLUMN COVER

Hide 84306 6.REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR

a.

Remove the spiral cable with steering angle sensor (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL).

NOTICE:
·

Do not replace the spiral cable with the battery connected and the ignition switch ON.

·

Do not rotate the spiral cable with the battery connected and the ignition switch ON.

·

Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.

·

Do not remove the steering angle sensor from the spiral cable.