Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2009.08–2010.08
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0274004 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1240  Yaw Rate Sensor Discrimination  


DESCRIPTION

The skid control ECU determines if the yaw rate and acceleration sensor identification information sent via CAN communication matches the yaw rate and acceleration sensor identification information memorized by the skid control ECU.

DTC Code DTC Detection Condition Trouble Area
C1240 The yaw rate and acceleration sensor identification information memorized by the skid control ECU does not match the yaw rate and acceleration sensor identification information sent via CAN communication for 1 second or more.
·

Proper yaw rate and acceleration sensor not installed

·

Master cylinder solenoid (Skid Control ECU)



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the yaw rate and acceleration sensor, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).

·

When replacing the master cylinder solenoid, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).



PROCEDURE

1.CHECK PART NUMBER (YAW RATE AND ACCELERATION SENSOR)
a.

Check that the proper yaw rate and acceleration sensor is installed.

OK:

Proper yaw rate and acceleration sensor installed.




OK

2.RECONFIRM DTC

NG

2.RECONFIRM DTC

b.

Turn the ignition switch off.


c.

Turn the ignition switch to ON.


d.

Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC C1240 output A
DTC not output B



A

REPLACE MASTER CYLINDER SOLENOID

B