Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2010.08
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0274004 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1442  Invalid Data Received from Deceleration Sensor  C1443  Invalid Data Received from Yaw Rate Sensor  


DESCRIPTION

The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.

DTC Code DTC Detection Condition Trouble Area
C1442 An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more. Yaw rate and acceleration sensor
C1443 An invalid data signal is transmitted continuously from the yaw rate and acceleration sensor for 10 seconds or more.

CAUTION / NOTICE / HINT

NOTICE:

When replacing the yaw rate and acceleration sensor, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK DTC

b.

Turn the ignition switch off.


c.

Start the engine and idle it for 60 seconds, and then stop the engine.


d.

Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTCs C1442 and/or C1443 are output A
DTCs C1442 and C1443 are not output B



A

B