The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1252 | The motor operates for 3 minutes or more. | ·
Brake booster with accumulator pump assembly ·
Pump motor wire harness condition ·
Master cylinder solenoid (Skid control ECU) ·
Hydraulic brake booster assembly |
The pump motor continues operation for the first 3 minutes, and then starts and stops repeatedly.
When replacing the master cylinder solenoid, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
When DTC C1253, C1254, C1256 or C1452 is output together with DTC C1252, inspect and repair the trouble area indicated by DTC C1253, C1254, C1256 or C1452 first.
Turn the ignition switch off.
Depress the brake pedal more than 40 times.
Turn the ignition switch to ON.
Check how the pump motor operates.
| Result | Proceed to |
|---|---|
| Pump motor does not operate | A |
| Pump motor operates continuously and does not stop | B |
| Pump motor operates intermittently | C |
| Pump motor operates, and then stops | D |
A
B
C
D
OK
NG
OK
NG
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Accumulator Sensor | Accumulator pressure sensor reading/ Min.: 0.00 V, Max.: 5.00 V | 3.58 to 5 V | If the value is constant regardless of the pump operation, an accumulator pressure sensor malfunction is suspected. |
Check the accumulator output value.
| Result | Proceed to |
|---|---|
| Output value is within "Normal Condition" range | A |
| Output value is out of "Normal Condition" range | B |
| Output value is constant regardless of pump operation | C |
A
B
C
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Turn the ignition switch off.
Turn the ignition switch to ON.
Wait for more than 5 minutes.
Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
B