Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2009.08–2010.08
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0274004 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1268  Transfer L4 Position Switch Circuit  C1283  L4 Position Switch  


DESCRIPTION

DTC C1283 is stored only in test mode.

DTC Code DTC Detection Condition Trouble Area
C1268 The skid control ECU receives an L4 abnormal status signal from the four wheel drive control ECU via CAN.
·

Transfer system


·

Master cylinder solenoid (Skid control ECU)


C1283 Stored only during test mode.

CAUTION / NOTICE / HINT

NOTICE:

When replacing the master cylinder solenoid, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.INSPECT TRANSFER L4 SHIFT
a.

Shift the transfer to L4, and then drive the vehicle and check that there are no problems with the transfer system.

OK:

There are no problems with the transfer system




OK

2.RECONFIRM DTC

NG

GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE)

2.RECONFIRM DTC

b.

Shift the transfer to L4, drive the vehicle, and then check for DTCs.

Result
Result Proceed to
DTC is output A
DTC is not output B



A

REPLACE MASTER CYLINDER SOLENOID

B