Home › Drivetrain › VF4BM TRANSFER / 4WD / AWD › TRANSFER SYSTEM
RM1440E _52 Drivetrain _056135 VF4BM TRANSFER / 4WD / AWD _0273959 TRANSFER SYSTEM T

VF4BM TRANSFER / 4WD / AWD  TRANSFER SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Transfer System
Symptom Suspected Area See page
Noise Oil (Level low) (Click here)
Oil (Wrong) (Click here)
Transfer faulty (Click here)
Oil leakage Oil (Level too high) (Click here)
Gasket (Damaged) (Click here)
Oil seal (Worn or damaged) (Click here)
O-ring (Worn or damaged) (Click here)
Switch from HIGH (H4L) to LOW (L4L) is impossible Harness or connector (Click here)
Transfer shift actuator assembly (Click here)
CAN communication system (Click here)
Transfer position switch (Click here)
Four wheel drive control ECU (Click here)
Transfer faulty (Click here)
Switch from LOW (L4L) to HIGH (H4L) is impossible Harness or connector (Click here)
Transfer shift actuator assembly (Click here)
CAN communication system (Click here)
Transfer position switch (Click here)
Four wheel drive control ECU (Click here)
Transfer faulty (Click here)
Switch from FREE (H4F) to LOCK (H4L) is impossible Harness or connector (Click here)
Transfer shift actuator assembly (Click here)
CAN communication system (Click here)
Transfer position switch (Click here)
Four wheel drive control ECU (Click here)
Transfer faulty (Click here)
Switch from LOCK (H4L) to FREE (H4F) is impossible Harness or connector (Click here)
Transfer shift actuator assembly (Click here)
CAN communication system (Click here)
Transfer position switch (Click here)
Four wheel drive control ECU (Click here)
Transfer faulty (Click here)
4LO indicator light does not come on Harness or connector (Click here)
Combination meter (Click here)
CAN communication system (Click here)
Four wheel drive control ECU (Click here)
Transfer position switch (Click here)
Transfer shift actuator assembly (Click here)
4LO indicator light remains on Four wheel drive control ECU (Click here)
Transfer position switch (Click here)
Combination meter (Click here)
Center differential lock indicator light does not come on Harness or connector (Click here)
Combination meter (Click here)
CAN communication system (Click here)
Four wheel drive control ECU (Click here)
Transfer position switch (Click here)
Transfer shift actuator assembly (Click here)
Center differential lock indicator light remains on Four wheel drive control ECU (Click here)
Transfer position switch (Click here)
Combination meter (Click here)