DTC C1282 is stored only in test mode.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1282 | Stored during test mode. | ·
Harness or connector ·
Transfer system ·
Master cylinder solenoid (Skid control ECU) |
When replacing the master cylinder solenoid, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
Disconnect the A6 skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A6-27 (EXI) - Body ground | ·
Ignition switch ON ·
Center differential free |
11 to 14 V |
·
Ignition switch ON ·
Center differential locked |
Below 1.5 V |
| *a | Front view of wire harness connector
(to Skid Control ECU) |
OK
NG
Switch the vehicle to test mode, perform the center differential lock detection signal check, and then check that DTC C1282 is cleared (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>TEST MODE PROCEDURE).
| Result | Proceed to |
|---|---|
| DTC is not cleared | A |
| DTC is cleared | B |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
Disconnect the A6 skid control ECU connector.
Disconnect the F47 four wheel drive control ECU connector.
Disconnect the B47 transfer shift actuator connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A6-27 (EXI) - F47-14 (P1) | Always | Below 1 Ω |
| A6-27 (EXI) - B47-9 (CDL) | Always | Below 1 Ω |
| A6-27 (EXI) - Body ground | Always | 10 kΩ or higher |
OK
NG