| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1340 | An open circuit is detected in the EXI circuit of the skid control ECU. | ·
Harness or connector ·
Transfer system ·
Master cylinder solenoid (Skid control ECU) |
When replacing the master cylinder solenoid, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
Disconnect the A6 skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A6-27 (EXI) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to Skid Control ECU) |
OK
NG
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
Disconnect the A6 skid control ECU connector.
Disconnect the F47 four wheel drive control ECU connector.
Disconnect the B47 transfer shift actuator connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A6-27 (EXI) - F47-14 (P1) | Always | Below 1 Ω |
| A6-27 (EXI) - B47-9 (CDL) | Always | Below 1 Ω |
| A6-27 (EXI) - Body ground | Always | 10 kΩ or higher |
| B47-10 (GND) - Body ground | Always | Below 1 Ω |
OK
NG