Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2010.08
RM1440E _54 Brake _056142 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0274004 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C120A  ECU Initial Setting Incomplete  


DESCRIPTION

When the master cylinder solenoid (skid control ECU) is replaced, the master cylinder solenoid (skid control ECU) must be informed that the vehicle is equipped with downhill assist control.

DTC Code DTC Detection Condition Trouble Area
C120A The master cylinder solenoid is not informed that the vehicle is equipped with downhill assist control and downhill assist control operates. Calibration not performed

PROCEDURE

1.PERFORM CALIBRATION
a.

Perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).

NOTICE:

If a DTC is output after replacing the master cylinder solenoid, it is possible that calibration has not been performed or the zero point calibration data was not cleared when calibration was performed




NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
DTC is not output B



A

3.CHECK TEST MODE DTC

B

END

3.CHECK TEST MODE DTC
a.

Switch the vehicle to test mode, perform the downhill assist control switch signal check, and then check that DTC C1379 is cleared (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>TEST MODE PROCEDURE).

Result
Result Proceed to
DTC is not cleared A
DTC is cleared B



A

B