Home › Brake › PARKING BRAKE › PARKING BRAKE PEDAL
RM1440E _54 Brake _056146 PARKING BRAKE _0274014 PARKING BRAKE PEDAL A

PARKING BRAKE  PARKING BRAKE PEDAL  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55045 2.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

a.

Remove the lower instrument panel finish panel sib-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL).


Hide 58910C 3.REMOVE REAR CONSOLE BOX ASSEMBLY

a.

Remove the rear console box assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>REMOVAL).


Hide 81980 6.REMOVE TURN SIGNAL FLASHER ASSEMBLY

Hide 46200 7.REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY

a.
C361683

Release the parking brake pedal.


b.

Disconnect the parking brake switch connector.


c.

Remove the 3 nuts and parking brake control pedal assembly.


Hide 33550 8.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

Transmission Type See procedure
A750F (Click here)
A750E (Click here)

Hide 46410 9.REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY

a.
C217117

Remove the lock nut and adjusting nut.


b.

Remove the clip.


c.

Pull up the parking pedal claw.


d.

Remove the No. 1 parking brake cable assembly.


e.

Remove the 4 nuts and 3 bolts from the No. 1 parking brake cable assembly.

C215294


f.
C215295

Remove the lock nut, adjusting nut and No. 1 parking brake cable assembly from the parking brake equalizer.


g.

Disconnect the No. 1 parking brake cable No. 3 clamp from the No. 1 parking brake cable.


Hide 46252 10.REMOVE PARKING PEDAL PAD

a.

Remove the parking pedal pad.