Check the radio automatic station search function.
Check the radio automatic station search function by activating it.
| Result | Proceed to |
|---|---|
| Automatic station search function does not stop | A |
| Automatic station search function stops on a station | B |
A
B
Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
| Result | Proceed to |
|---|---|
| Optional components are not installed | A |
| Optional components are installed | B |
Do not remove optional components without the permission of the customer.
A
B
Preparation for check
Remove the antenna connector from the radio and display receiver assembly.
Check for noise
Turn the ignition switch to ACC with the radio and display receiver assembly connector connected.
Turn the radio on and tune into AM mode.
Place a screwdriver, thin wire or other metal object on the radio and display receiver assembly antenna jack and check that noise can be heard from the speakers.
Noise can be heard from the speakers.
OK
NG
Check for continuity in the window glass antenna wire.
Check for continuity at the center of each antenna wire as shown in the illustration.
When cleaning the glass, wipe it in the direction of the wire with a soft dry cloth. Take care not to damage the wire. Do not use detergents or glass cleaners with abrasive ingredients. When measuring resistance, wrap a piece of tin foil around the tip of each probe and press the foil against the wire with your finger, as shown in the illustration.
There is continuity in the window glass antenna wire.
| *a | Tester Probe |
| *b | Antenna Wire |
| *c | Tin Foil |
OK
NG
Disconnect the radio and display receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G33-2 (R+B1) - Body ground | Ignition switch ACC
Radio switch on and FM or AM selected |
11 to 14 V |
| *a | Component without harness connected
(Radio and Display Receiver Assembly) |
OK
NG
Replace the amplifier antenna assembly and check if radio broadcasts can be received normally (See page Audio / Visual / Telematics>AUDIO / VIDEO>AMPLIFIER ANTENNA>REMOVAL).
Radio broadcasts can be received normally.
OK
NG
Replace the No. 2 antenna cord sub-assembly and check if radio broadcasts can be received normally (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL).
Radio broadcasts can be received normally.
OK
NG
Replace the No. 2 instrument panel wire and check if radio broadcasts can be received normally (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL).
Radio broadcasts can be received normally.
OK
NG