Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM › from 2013.08
RM1440E _58 Vehicle Interior _056156 THEFT DETERRENT / KEYLESS ENTRY _0274066 ENGINE IMMOBILISER SYSTEM J

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM  Security Indicator Light Circuit  


DESCRIPTION

When the engine immobiliser system is set, the security indicator light (telltale light assembly) blinks continuously, but does not illuminate if the engine immobiliser system is not set.


WIRING DIAGRAM

B353562E09
1.021,1.875 1.313,2.052 0.292,0.177 10 false F35 1,2.031 2.5,2.552 1.5,0.521 10 false Security Indicator Light (Telltale Light Assembly) 4.688,1.875 4.979,2.052 0.292,0.177 10 false F34 4.656,2.031 6.073,2.615 1.417,0.583 10 false Transponder Key ECU Assembly 1.344,1.083 1.719,1.26 0.375,0.177 10 false GND 1.188,0.969 1.323,1.146 0.135,0.177 10 false 1 2.021,1.083 2.24,1.26 0.219,0.177 10 false LP 2.26,0.969 2.396,1.146 0.135,0.177 10 false 6 5.042,1.083 5.354,1.26 0.313,0.177 10 false IND 4.865,0.979 5.094,1.156 0.229,0.177 10 false 8

CAUTION / NOTICE / HINT

NOTICE:

When replacing the transponder key ECU assembly, refer to the Service Bulletin.


PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR)
a.

Check that the security indicator light illuminates when operating it with the Active Test (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DATA LIST / ACTIVE TEST).

Immobiliser
Tester Display Test Part Control Range Diagnostic Note
Security Indicator Security indicator light ON/OFF The test is possible when the following conditions are met:

The key is in the ignition key cylinder.



OK:

Security indicator light can be turned on and off using the intelligent tester.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT SECURITY INDICATOR LIGHT (TELLTALE LIGHT ASSEMBLY) (SECURITY INDICATOR LIGHT)
2.INSPECT SECURITY INDICATOR LIGHT (TELLTALE LIGHT ASSEMBLY) (SECURITY INDICATOR LIGHT)
a.

Remove the security indicator light (telltale light assembly) (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>SECURITY INDICATOR LIGHT ASSEMBLY>REMOVAL).


b.

Inspect the security indicator light (telltale light assembly) (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>SECURITY INDICATOR LIGHT ASSEMBLY>INSPECTION).



OK

3.CHECK HARNESS AND CONNECTOR (TELLTALE LIGHT - TRANSPONDER KEY ECU AND BODY GROUND)

NG

REPLACE SECURITY INDICATOR LIGHT (TELLTALE LIGHT ASSEMBLY)

3.CHECK HARNESS AND CONNECTOR (TELLTALE LIGHT - TRANSPONDER KEY ECU AND BODY GROUND)
a.

Disconnect the F35 security indicator light (telltale light assembly) connector.


b.

Disconnect the F34 transponder key ECU assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F35-6 (LP) - F34-8 (IND) Always Below 1 Ω
F35-1 (GND) - Body ground Always Below 1 Ω
F35-6 (LP) or F34-8 (IND) - Body ground Always 10 kΩ or higher




OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR