The security courtesy switch is built into the hood lock. This switch turns on when the engine hood is opened and turns off when the engine hood is closed.
Using the intelligent tester, read the Data List (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Hood Courtesy SW | Security courtesy switch /
ON or OFF |
ON: Engine hood open
OFF: Engine hood closed |
- |
ON (engine hood open) and OFF (engine hood closed) appear on screen according to condition of engine hood.
OK
(See pageVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>PROBLEM SYMPTOMS TABLE)
NG
Disconnect the A19 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Unlock position | Below 1 Ω |
| 1 - 2 | Lock position | 10 kΩ or higher |
OK
NG
Disconnect the A19 switch connector.
Remove the main body ECU (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A19-2 - A-20 (HCTY) | Always | Below 1 Ω |
| A19-1 - Body ground | Always | Below 1 Ω |
| A19-2 or A-20 (HCTY) - Body ground | Always | 10 kΩ or higher |
OK
NG