Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE HOOD COURTESY SWITCH › from 2013.08
RM1440E _58 Vehicle Interior _056156 THEFT DETERRENT / KEYLESS ENTRY _0274068 ENGINE HOOD COURTESY SWITCH A

THEFT DETERRENT / KEYLESS ENTRY  ENGINE HOOD COURTESY SWITCH  INSTALLATION  


PROCEDURE

Hide 53510 1.INSTALL HOOD LOCK ASSEMBLY

a.

Apply MP grease to the sliding areas of the hood lock assembly.


b.

Connect the hood lock control cable assembly.


c.

Connect the connector.


d.
B237114E01
2.795,0.807 2.989,0.956 0.194,0.149 10 (1) 0.64,0.943 0.834,1.092 0.194,0.149 10 (2) 1.635,1.6 1.829,1.749 0.194,0.149 10 (3)

Install the hood lock assembly with the 3 bolts in the order shown in the illustration.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 53629 2.INSTALL HOOD LOCK CONTROL CABLE COVER

a.
B353476E01
2.033,0.996 2.236,1.144 0.203,0.148 10 (1) 0.405,0.92 0.608,1.067 0.203,0.148 10 (2)

Pass the hood lock control cable assembly through the hood lock control cable cover.


b.

Attach the claw to install the hood lock control cable cover.


c.

Install the 2 screws in the order shown in the illustration.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 86520 3.INSTALL LOW PITCHED HORN ASSEMBLY

Hide 53115B 4.INSTALL RADIATOR GRILLE BRACKET

Hide 86510 5.INSTALL HIGH PITCHED HORN ASSEMBLY

Hide 52119A 6.INSTALL FRONT BUMPER COVER (w/ TOYOTA Parking Assist-sensor System)

Hide 52119A 7.INSTALL FRONT BUMPER COVER (w/o TOYOTA Parking Assist-sensor System)