Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
If the side airbag was deployed, replace the separate type front seatback assembly with the necessary parts in accordance with the extent of the collision damage.
71100S
2.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
71100S
3.REMOVE FRONT SEAT ASSEMBLY (for Power Seat)
71706
4.REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY (w/ Climate Control Seat System)
71769A
5.REMOVE FRONT SEATBACK BOARD CLIP (w/ Climate Control Seat System)
6.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat)
Remove the rubber band from the separate type front seat cushion spring assembly.
| *1 | Rubber Band |
Detach the claw to disconnect the airbag connector.
Detach the 3 airbag wire harness clamps.
Detach the fastening tape to disconnect the airbag wire harness.
| *1 | Fastening Tape |
Remove the 3 hog rings.
Open the 2 fasteners and separate type front seatback cover.
Remove the nut to disconnect the seatback cover bracket from the separate type front seatback spring assembly.
Using a screwdriver, detach the 4 claws to remove the 2 front seat headrest supports.
Remove the separate type front seatback cover with pad from the separate type front seatback spring assembly.
7.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat)
w/o Climate Control Seat System:
Remove the rubber band from the separate type front seat cushion spring assembly.
| *1 | Rubber Band |
Detach the claw to disconnect the airbag connector.
Detach the 3 airbag wire harness clamps.
Detach the fastening tape to disconnect the airbag wire harness.
| *1 | Fastening Tape |
Remove the 3 hog rings.
Open the 2 fasteners and separate type front seatback cover.
| *A | for Cloth Seat | *B | for Synthetic Leather Seat |
Remove the nut and detach the 2 hooks to disconnect the seatback cover bracket from the separate type front seatback spring assembly.
Using a screwdriver, detach the 4 claws to remove the 2 front seat headrest supports.
Remove the separate type front seatback cover with pad from the separate type front seatback spring assembly.
w/ Climate Control Seat System:
Detach the claw to disconnect the airbag connector.
Detach the 3 airbag wire harness clamps.
Detach the fastening tape to disconnect the airbag wire harness.
| *1 | Fastening Tape |
Detach the 7 hooks.
Remove the 5 hog rings.
Remove the nut and detach the 2 hooks to disconnect the seatback cover bracket from the separate type front seatback spring assembly
Using a screwdriver, detach the 4 claws to remove the 2 front seat headrest supports.
Remove the separate type front seatback cover with pad from the separate type front seatback spring assembly.
73920A
8.REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY
Detach the 2 clamps to disconnect the front seat side airbag wire harness.
Using an E10 "TORX" socket wrench, remove the 2 nuts and front seat side airbag assembly.
The nuts must not be reused.
Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.