Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
71072S
1.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER
Using hog ring pliers, install the seat cushion cover to the seat cushion pad with new hog rings.
| *1 | Hog Ring Pliers |
Be careful not to damage the cover.
When installing the hog rings, avoid wrinkling the cover.
2.INSTALL SEAT CUSHION COVER WITH PAD
Install the seat cushion cover with pad.
for Front Passenger Side:
Attach the claw to connect the connector.
Attach the hooks.
Connect the seat heater connector and attach the 3 wire harness clamps.
Attach the 2 hooks.
Connect the airbag wire harness.
Attach the fastening tape to close the cover.
Connect the seat heater connector and attach the wire harness clamp.
Install the rubber band to the seat cushion spring.
73240
3.INSTALL FRONT SEAT INNER BELT ASSEMBLY LH
71862
4.INSTALL FRONT SEAT INNER CUSHION SHIELD LH
71861
5.INSTALL FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)
84920
6.INSTALL LUMBAR SWITCH ASSEMBLY (for Driver Side)
84922C
7.INSTALL FRONT POWER SEAT SWITCH LH
71812D
8.INSTALL FRONT SEAT CUSHION SHIELD LH
84921A
9.INSTALL RECLINING POWER SEAT SWITCH KNOB
84921B
10.INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
11.INSTALL FRONT SEAT ASSEMBLY
Install the front seat assembly (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>INSTALLATION).